CockpitSimulator Bridge Software update

General
#1

CockpitSimulator Bridge v2022.1.0 (Nov. 20, 2022)

  • Bridge software architecture upgrade
  • Added support for X-Plane 12
  • Upgraded support for ZIBO 737NG
  • Added support for: CDU 737MAX / CDU 747 / CDU 777

Visit: https://www.cockpit-simulator.com/software/

CSBS1
CSBS11125Ă—675 319 KB

#2

Thanks for the update!
Under “Status” it shows my CDU as Firmware v3.0.1 and it says “new firmware available”. Device test tab works fine however if I go to “Firmware Update” it says “NO DFU DEVICE DETECTED”.

#4

If you want use FIRMWARE UPDATE, you can try the following.

  1. Press and holding the INIT REF and number 5 button of the CDU at the same time, then connect the USB to the computer to enter the update mode. (CDU backlight will flash if you entered update mode)
  2. Run CockpitSimulator.exe
  3. Select the FIRMWARE UPDATE page and click START FLASH
#5

Thank you. I was able to update to v3.0.2A.

#6

I have exactly the same problem as DeshMindER.
Additionally, Windows detects the software as “dangerous”.
Obviously this is a great piece of hardware (really like it), but there was no more money to develop a user-friendly and working software…
So sad.

1 Like
#7

Thanks for your input and give us some time.
This problem can be solved.

#8

Warum bekomme ich nicht die Software CockitSimulator BrĂĽcke herunter geladen und Installiert ???
Muss ich jetzt ein Studium Elektronik machen???
Die Hardware CDU, MCP, und die zwei EFIS sind nicht schlecht, aber die Software!!!

#9

Warum bekommt man nach Tagen von Cockpit Master keine Hilfestellung???

#10

I don’t understand what you said about not being able to download, what problems did you encounter while downloading?

#11

when i try to open the file the message i get is "make sure you trust cockpitsimulator v2024.5.1.exe before opening ,

#12

This should be a pop-up prompt for your computer’s antivirus software. Just click “Yes” and run the bridge.